Subaru IMPREZA GD 2007 Series Manual page 3724

asieps_tobira_IM_US.book 33 ページ ２０１２年１月１７日 火曜日 午後３時４８分
Diagnostic Procedure with Diagnostic Trouble Code (DTC)
CRUISE CONTROL SYSTEM (DIAGNOSTICS)
Q: DTC 62
Neutral position switch malfunction is detected.
TROUBLE SYMPTOM:
Cruise control cannot be set.
Refer to DTC 14 for diagnostic procedure.
<Ref. to CC(ETC)(diag)-25, DTC 14, Diagnostic Procedure with Diagnostic Trouble Code (DTC).>
R: DTC 63
Malfunction of vehicle speed signal variation is detected.
TROUBLE SYMPTOM:
Cruise control cannot be set. (Cancelled immediately.)
Refer to DTC 22 for diagnostic procedure.
<Ref. to CC(ETC)(diag)-30, DTC 22, Diagnostic Procedure with Diagnostic Trouble Code (DTC).>
S: DTC 64
Malfunction related to engine is detected.
Refer to the Engine Diagnostic Procedure for diagnostic procedure.
<Ref. to EN(H4SO)(diag)-2, PROCEDURE, Basic Diagnostic Procedure.>
<Ref. to EN(H4DOTC)(diag)-2, PROCEDURE, Basic Diagnostic Procedure.>
<Ref. to EN(STI)(diag)-2, PROCEDURE, Basic Diagnostic Procedure.>
T: DTC 65
Cruise control command switch malfunction is detected.
While the command switch is pressed ON for a long time (approximately two minutes), stuck ON condition
is detected.
Trouble symptom:
• Cruise control cannot be set. (Cancelled immediately.)
• Cruise control cannot be released.
Refer to DTC 11 for diagnostic procedure. <Ref. to CC(ETC)(diag)-19, DTC 11, Diagnostic Procedure with
Diagnostic Trouble Code (DTC).>
U: DTC 66
Cruise control calculation malfunction is detected.
Refer to the Engine Diagnostic Procedure for diagnostic procedure. <Ref. to EN(H4SO)(diag)-2, PROCE-
DURE, Basic Diagnostic Procedure.> <Ref. to EN(H4DOTC)(diag)-2, PROCEDURE, Basic Diagnostic Pro-
cedure.> <Ref. to EN(STI)(diag)-2, PROCEDURE, Basic Diagnostic Procedure.>
CC(ETC)(diag)-33