Subaru IMPREZA GD 2007 Series Manual page 3701

asieps_tobira_IM_US.book 10 ページ ２０１２年１月１７日 火曜日 午後３時４８分
CRUISE CONTROL SYSTEM (DIAGNOSTICS)
8) When the set speed is canceled by itself (without
any cancel operations such as applying brake) or
when the cruise control could not be set by per-
forming the setting operation, selecting the {Check
Cancel Code} on the engine malfunction diagnosis
screen will display the DTC on the select monitor
display.
NOTE:
There are {Latest Code} and {Memory Code} in
DTC. The latest code recognized during current
test drive is displayed in {Latest Code} and those
recognized during past test drives are displayed in
{Memory Code}. DTCs by the diagnosis of faulty
switches relating to the system and cruise control
are displayed in {Memory Code}.
9) Perform Engine DTC Clear Memory operation.
• <Ref. to EN(H4SO)(diag)-47, OPERATION,
Clear Memory Mode.>
• <Ref. to EN(H4DOTC)(diag)-53, OPERATION,
Clear Memory Mode.>
• <Ref. to EN(STI)(diag)-48, OPERATION, Clear
Memory Mode.>
DTCs of switches relating to the system and cruise
control are deleted by clearing memory on the en-
gine side.
NOTE:
The latest code will be cleared by turning ignition
switch to OFF.
3. REAL-TIME DIAGNOSIS
1) Connect the Subaru Select Monitor.
2) Turn the ignition switch and cruise control main
switch to ON.
3) Connect the Subaru Select Monitor.
4) Select {2. Each System Check} in the «Main
Menu» screen.
5) Select {Engine Control System} in the «System
Selection» screen.
6) Select [OK] after the information of engine type
has been displayed.
7) Select {Current Data Display & Save} in the «En-
gine Control System Diagnosis» screen.
Subaru Select Monitor
8) Make sure that normal display is shown when
operated as follows:
• Depress and release the brake pedal. (Stop light
switch and brake switch are turned ON.)
• Turn the «SET/COAST» switch to ON.
• Turn the "RES/ACC" switch to ON.
• Turn the «CANCEL» switch to ON. (The «SET/
COAST» switch and the «RES/ACC» turn to ON si-
multaneously.)
• Depress or release the clutch pedal. (MT model)
• Place the shift lever in neutral position. (MT mod-
el)
• Move the select lever to "P" or "N" range. (AT
model)
NOTE:
• For details concerning the operation procedures,
refer to the "SUBARU SELECT MONITOR OPER-
ATION MANUAL".
• For the DTC, refer to the List of Diagnostic Trou-
ble Code (DTC). <Ref. to CC(ETC)(diag)-17, List of
Diagnostic Trouble Code (DTC).>
CC(ETC)(diag)-10