Toyota Tundra 2005 Service - Repair - Maintenance page 2324

AT−14
AUTOMATIC TRANSMISSION (A750E, A750F)
A
B
A
A
A
B
Orange
Blue
Clamp
A
(b)
A
A
A
D12705
10.
Clamp
(a)
(b)
HINT:
In order to install the ATF temperature sensors properly, check
the wire harness color prior to installation.
D12704
Sensor wire harness:
11.
(a)
(b)
D12703
12.
HINT:
Remove any packing material, and be careful not to spill oil on
the contacting surfaces of the transmission case and the oil
pan.
Using a new gasket, install the oil pan with the 20 bolts.
13.
D13866
− VALVE BODY ASSEMBLY
Install the 19 bolts and the valve body.
Torque: 11 N·m (112 kgf·cm, 8 ft·lbf)
Bolt length:
Bolt A: 25 mm (0.98 in.)
Bolt B: 36 mm (1.42 in.)
INSTALL TEMPERATURE SENSOR
Connect the 7 solenoid valve connectors.
Install the 2 temperature sensors and clamps to the valve
body with the 2 bolts.
Torque:
A: 11 N·m (112 kgf·cm, 8 ft·lbf)
B: 10 N·m (100 kgf·cm, 7 ft·lbf)
Bolt length:
Bolt A: 36 mm (1.42 in.)
Bolt B: 12 mm (0.47 in.)
Wire harness
for linear control
for oil temp. warning lamp
INSTALL OIL STRAINER
Install a new O−ring.
Install the oil strainer with the 4 bolts.
Torque: 10 N·m (100 kgf·cm, 7 ft·lbf)
INSTALL OIL PAN
Torque: 4.4 N·m (45 kgf·cm, 39 in·lbf)
FILL TRANSMISSION (See page AT−4)
Color
Orange
Blue