035-741 ECM Phase C Flag Timeout RAP
BSD-ON:
BSD 34.1 - FAX
There is a time-out during Phase-C (message transmission).
Procedure
•
There is a problem with the receiving Fax. Ask customer to cancel the job and resend.
•
Check the remote machine settings and line status, then perform the operation again.
•
Check the Fax line connection (telephone line).
•
Ensure that the customer is programming a job within the parameters of the machine uti-
lizing the UI.
•
Disconnect then reconnect the PWBs in the FAX Module
•
Check the sw version of the fax & controller sw - update if required
•
Perform FAX Diagnostic
GP 13
•
Replace the FAX PWB
(PL
18.5).
Status Indicator RAPs
035-741, 035-742
035-742 EOR Send or Receive RAP
BSD-ON:
BSD 34.1 - FAX
After the EOR (End of Re-transmission) signal was sent, the ERR (Response For End Of
Transmission) signal was returned, or the EOR-Q (End Of Re-transmission-Quit) signal was
received by the Fax controller.
Procedure
•
There is a problem with the receiving Fax. Ask customer to cancel the job and resend.
•
Check the remote machine settings and line status, then perform the operation again.
•
Check the Fax line connection (telephone line).
•
Ensure that the customer is programming a job within the parameters of the machine uti-
lizing the UI.
•
Disconnect then reconnect the PWBs in the FAX Module
•
Check the sw version of the fax & controller sw - update if required
•
Perform FAX Diagnostic
•
Replace the FAX PWB
07/2011
2-670
BUS Updated 12/2011
GP 13
(PL
18.5).
WorkCentre 5335 Family Service Documentation
Initial Issue