016-911 Multi-Paper Required On A Single Tray Rap; 016-940 Duplex Output Side 1 And 2 Size Difference Rap - Xerox workcentre 5335 series Service Manual

016-911 Multi-Paper Required On A Single Tray RAP

The paper and staples requested by the print specification are not loaded, or, Different sizes
and/or types of paper switching are requested from the same Tray.
Procedure
• Force this Job to run and follow the panel display to replenish the paper, switch the paper,
and replenish the staples. Or, cancel this Job.
• Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
• Check the sw version of the controller sw - update if required
Status Indicator RAPs
016-911, 016-940

016-940 Duplex Output Side 1 and 2 Size Difference RAP

After the start of a job with Duplex Output selected, a difference was detected in size
between side 1 and side 2.
Procedure
• Specify the job to avoid the detection conditions.
• Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
• Check the sw version of the controller sw - update if required
(GP 16)
07/2011
2-280
BUS Updated 12/2011
(GP 16)
Initial Issue
WorkCentre 5335 Family Service Documentation