Table of Contents
Advertisement
016-722 Staple Position RAP
The job was cancelled when the Staple Position could not be determined.
Initial Actions
Ensure the staple position selection matches the available staple position in the finisher.
Procedure
•
Set the Staple reference point, paper size, etc. of the Print Data that is sent to the printing
section to be the ones that can be processed by the machine.
•
Check the system at the client side.
•
Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
•
Check the sw version of the controller sw - update if required
Status Indicator RAPs
016-722, 016-723
016-723 Punch Position Error RAP
The job is canceled due to impossible Punch position, paper size, etc. Punch position that is
not supported by this machine or the paper size that is not supported by the Finisher was spec-
ified.
Procedure
•
Set the Punch reference point, paper size, etc. of the Print Data that is sent to the printing
section to be the ones that can be processed by the machine.
•
Check the system at the client side.
•
Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
•
Check the sw version of the controller sw - update if required
07/2011
2-240
BUS Updated 12/2011
Initial Issue
WorkCentre 5335 Family Service Documentation
Advertisement
Table of Contents
