116-333 Localtalk Software Rap; 116-334 Ess Nvm Data Compare Fail Rap - Xerox workcentre 5335 series Service Manual

116-333 LocalTalk Software RAP

Due to an error in software processing, subsequent processes cannot be performed.
Initial Actions
Power Off/On
Procedure
• Change the system data 700-530 to "0" and disable the automatic startup boot operation
at SystemFail (make sure to reset to 1 when complete
• Specially check for faulty ports or Net connection. Check which of the following ports is
faulty.
– SNTP
– NetWare
– Salutation IO
– SMB
– Port 9100
– USB
– lpd
– FTP Serv
– MailIO
– IPP
– Check the sw version of the controller sw - Reload Software
– Replace ESS PWB (PL 35.2) (If not fixed by this, reinstall the original ESS PWB)
Status Indicator RAPs
116-333, 116-334

116-334 ESS NVM Data Compare Fail RAP

System Cont detects ESS-NVM with factory settings is installed] or [Illegal ESS-NVM data
is occurring].
Procedure
• As powering OFF then ON after a detection of 116-334 will presumably cause other errors
124-3xx that indicate various data mismatches between the three locations, resolve
one(s) following the corrective actions for the relevant Fault Code(s).
• Ensure that the customer is programming a job within the parameters of the machine uti-
lizing the UI.
• Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
• Check the sw version of the controller sw - update if required
• Replace RAM DIMM on ESS PWB
• Replace ESS PWB
(GP 16)
07/2011
2-858
BUS Updated 12/2011
(PL 35.2)
(PL 35.2) (If not fixed by this, reinstall the original ESS PWB)
WorkCentre 5335 Family Service Documentation
Initial Issue