REP 8.6 MSI Feed Roll
Parts List on
PL 13.2
Removal
1.
Switch off the power and disconnect the power cord.
2.
Open the Left Hand Cover. and perform the following
a.
Remove the Duplex Lower Chute.
b.
Remove the screws (2) and the MSI Top Cover.
Figure 1 Removing Screws
3.
Release the Core Roll locking tab from the shaft and slide it to the front
Figure 2 Roll
Initial Issue
WorkCentre 5335 Family Service Documentation
(Figure
1).
Screws
Chute
(Figure
Locking tab
BUS Updated 12/2011
4.
Slide the Feed Roll to the front, to clear the locating pin, and remove it
Locking pin
Replacement
1.
To install, carry out the removal steps in reverse order.
2.
Go to
HFSI Counter
and reset counter 954-804
2).
07/2011
4-67
(Figure
Figure 3 Removal
Repairs & Adjustments
3).
REP 8.6