116-384 Dcs Fatal Error Rap; 116-385 Idc Software Rap - Xerox workcentre 5335 series Service Manual

116-384 DCS Fatal Error RAP

DCS-related fatal error.
Due to an error in software processing, subsequent processes cannot be performed.
Initial Actions
Power Off/On
Procedure
• Ensure that the customer is programming a job within the parameters of the machine uti-
lizing the UI.
• Reinstall or replace the DIMM (PL 35.2).
• Remove and re-install or replace the System Memory and Page Memory DIMMs
35.2).
• Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
• Check the sw version of the controller sw - update if required
• Replace RAM DIMM on ESS PWB (PL
• Replace ESS PWB (PL 35.2) (If not fixed by this, reinstall the original ESS PWB)
Initial Issue
WorkCentre 5335 Family Service Documentation
35.2)
BUS Updated 12/2011

116-385 IDC Software RAP

An internal shutdown occurred after an IDC (scripting language) processing error.
Initial Actions
Power Off/On
Procedure
• Ensure that the customer is programming a job within the parameters of the machine uti-
lizing the UI.
• Reinstall or replace the DIMM
• Remove and re-install or replace the System Memory and Page Memory DIMMs
35.2).
(PL
• Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
• Check the sw version of the controller sw - update if required
• Replace RAM DIMM on ESS PWB
• Replace ESS PWB (PL 35.2) (If not fixed by this, reinstall the original ESS PWB)
07/2011
2-881
(PL 35.2).
(PL 35.2)
Status Indicator RAPs
116-384 , 116-385
(PL