024-748 Bates Numbering Digit Over Rap; 024-775 Print Booklet Sheets Counts Over (Not Field Attachment) Rap - Xerox workcentre 5335 series Service Manual

024-748 Bates Numbering Digit Over RAP

BSD-ON: BSD 3.1 - ESS - MCU Communication
BSD-ON: BSD 16.1 - ESS
Job Fail. The number of Bates Numbering digits is exceeded. In the process of printing Bates
Numbering, a maximum number of 9 or the user-specified number of digits is exceeded.
Procedure
• Reduce the number of documents to less than the user-specified number or reduce the
number of numbering digits in order to copy them again.
• Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
• Check the sw version of the controller sw - update if required
Initial Issue
WorkCentre 5335 Family Service Documentation
024-775 Print Booklet Sheets Counts Over (Not Field
Attachment) RAP
BSD-ON: BSD 3.1 - ESS - MCU Communication
BSD-ON: BSD 16.1 - ESS
Job Fail. A printer job whose paper quantity exceeds Booklet Paper Quantity is canceled. (This
occurs with a job without simplex/duplex setting.)
This fault is detected at the start of print.
The number of sheets per set for printer print exceeds a specific allowable number for
Booklet.
– If the number of sheets is larger by one, automatically only saddle stitching is dese-
lected and the sheets become folded in three for output.
– If folding is only selected, an allowable number of sheets per set are automatically
folded for output.
Because the Print Service operation of setting simplex/duplex is done by Driver, only the
operation without simplex/duplex setting is done by the machine.
As a detection of this Fail causes a job to be canceled, a message is only displayed indi-
cating the job is canceled.
Procedure
• Choose creation of every Booklet using a maximum number of sheets, or deselect Book-
let.
• When every Booklet is created using a maximum number of sheets, a specific signature is
laid out on top of each booklet consisting of the max number of sheets.
• Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
• Check the sw version of the controller sw - update if required
07/2011
2-405
BUS Updated 12/2011
Status Indicator RAPs
024-748, 024-775