Table of Contents
Advertisement
024-949 Tray 4 Position RAP
BSD-ON:
BSD 7.4 - Tray 4 Paper Size Sensing (TTM)
The Tray 4 Paper Size Switch detected no tray.
Initial Actions
•
Switch the power off, then on.
•
Pull out and re-insert Tray4.
Procedure
Check the following:
•
Broken link and breakage at the bottom of the tray
•
The Actuator at the rear of the Tray for operation failure
•
The Tray 4 Paper Size Switch for failure:
[074-104]
(PL
11.12)
•
The connection between the Tray 4 Paper Size Sensor
PWB
P/J548
for open circuit, short circuit, and poor contact
Reload the machine software
(GP
16). If no problems are found, replace the Tray Module PWB
(PL
11.13).
Status Indicator RAPs
024-949, 024-950
Analog Monitor [074-200];Component Control
P/J103
and the Tray Module
BUS Updated 12/2011
024-950 Tray 1 No Paper RAP
BSD-ON:
BSD 7.5 - Tray 1 Paper Stacking
Tray 1 is out of paper.
Initial Actions
•
Power Off/On
Procedure
Check the installation of the Tray 1 No Paper Sensor
tor. The Sensor is installed correctly and the actuator works.
Y
N
Reinstall the Sensor.
Execute
Component Control
[071-101 Tray 1 No Paper Sensor]. Manually activate the Tray 1
No Paper Sensor
(PL
9.5). The display changes.
Y
N
Go to
BSD 7.5 - Tray 1 Paper
Sensor. Refer to the
OF
99-2, Transmissive Sensor RAP.
Go to the
071-210
RAP to check the Tray 1 Feed LIft Motor.
•
Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
•
Check the sw version of the controller sw - update if required
07/2011
2-416
(PL
9.4) and the operation of the actua-
Stacking, Troubleshoot the circuit of the Tray 1 No Paper
(GP
16)
WorkCentre 5335 Family Service Documentation
Initial Issue
Advertisement
Table of Contents
