035-703 DCN Receive at Phase B Send RAP
BSD-ON:
BSD 34.1 - FAX
DCN (Distributed Computer Network) signal was received from the receiving Fax when send-
ing in Phase-B (pre-message processing).
Procedure
•
There is a problem with the receiving Fax. Ask customer to cancel the job and resend.
•
Check the remote machine settings and line status, then perform the operation again.
•
Check the Fax line connection (telephone line).
•
Ensure that the customer is programming a job within the parameters of the machine uti-
lizing the UI.
•
Disconnect then reconnect the PWBs in the FAX Module
•
Check the sw version of the fax & controller sw - update if required
•
Perform FAX Diagnostic
GP 13
•
Replace the FAX PWB
(PL
18.5).
Initial Issue
WorkCentre 5335 Family Service Documentation
035-704 Destination Polling Error RAP
BSD-ON:
BSD 34.1 - FAX
Polling could not be done because the receiving Fax does not support Polling Send function, or
the stored document/original was not set.
Procedure
•
There is a problem with the receiving Fax. Ask customer to cancel the job and resend.
•
Check the remote machine settings and line status, then perform the operation again.
•
Check the Fax line connection (telephone line).
•
Ensure that the customer is programming a job within the parameters of the machine uti-
lizing the UI.
•
Disconnect then reconnect the PWBs in the FAX Module
•
Check the sw version of the fax & controller sw - update if required
•
Perform FAX Diagnostic
•
Replace the FAX PWB
07/2011
2-651
BUS Updated 12/2011
GP 13
(PL
18.5).
035-703 , 035-704
Status Indicator RAPs