Xerox workcentre 5335 series Service Manual page 1133

14. Remove the Front Cover (Figure 12).
a. Remove the Screws (3).
b. Pull the top of the cover out and lift it off.
Figure 12 Removing Screws
15. Remove the Toner Cartridge Connector
a. Disconnect the PJ (1).
b. Remove Connector (1 Screw).
c. Release the wire harness from the front clamps and left side of the Cartridge Guide.
c
Figure 13 Wires & PJ
Repairs & Adjustments
REP 9.1
a
(Figure 13).
a
b
BUS Updated 12/2011
16. Remove the Toner Cartridge Guide
a. On the left rear, remove the Dispenser Tube Screw (1).
b. Loosen the front Screws (2).
c. Lift the front of the guide up and remove the guide.
a
Figure 14 Removing Screws
17. Remove the ROS Cover (Figure
a. Remove the Screws (2) on the left side of the cover.
b. Remove the top Screw (1).
c. Move the cover to the left and remove it.
a
Figure 15 Removing The Cover
07/2011
4-72
(Figure 14).
b
15).
c
WorkCentre 5335 Family Service Documentation
b
Initial Issue