Rep 6.6 Led Lamp Pwb - Xerox workcentre 5335 series Service Manual

REP 6.6 LED Lamp PWB

Parts List on PL 1.4
Removal
NOTE: Do not touch the chip on the LED Lamp PWB.
1. Switch off the power and disconnect the power cord.
2. Open the Platen Cover or DADF.
3. Remove the Platen Glass (REP 6.3)
4. Move the Full Rate Carriage to the notch on the Frame.
5. Disconnect the Lamp Wire Harness (Figure
(1) Move the Block of the Connector Housing in the direction of the arrow.
(2) Disconnect the Lamp Wire Harness.
Figure 1 Disconnecting Lamp Wire Harness
6. Remove the LED Bracket (Figure 2)
(1) Remove the screws (x3).
(2) Remove the LED Bracket.
Repairs & Adjustments
REP 6.6
1)
BUS Updated 12/2011
7. Remove the LED Lamp PWB
(1) Remove the screws (x2).
(2) Remove the LED Lamp PWB.
Figure 3 LED Lamp PWB Removal
Replacement
1. To install, carry out the removal steps in reverse order.
2. When installing the LED Lamp PWB, tighten the screw in the order of 1 then 2
3. When installing the LED Bracket, tighten the screw in the order of 3 to 5
07/2011
4-44
Figure 2 LED Bracket
(Figure 3)
WorkCentre 5335 Family Service Documentation
(Figure 4)
(Figure 4)
Initial Issue