Table of Contents
Advertisement
124-708 Output Tray Changed Failure RAP
The output tray has been changed to the Sub Tray because a failure was detected in the spec-
ified output tray.
The paper was output from the center tray instead of from the selected tray
1.
A different paper size other than the selected size was output for double-sided set-
ting
2.
Puncher of Finisher C malfunctioned
[(1) Sub Tray output when there is a size mismatch during double-sided setting]
•
When there is a size mismatch, Simplex setting outputs to the selected tray and
Duplex setting outputs to the Sub tray.
•
The aim in changing the output to the Sub Tray based on the Sheet Delivered
receive timing from the IOT is displayed in the Control Panel which displays "Copy-
ing" message when the [Start] button is pressed, until the IOT stops.
•
There is no special display in the driver.
[(2) Sub Tray output when the Finisher malfunctioned]
•
Decolor and Puncher failures are not SubSystemFail, they are LocalFail.
•
When Decolor fails, output goes to the selected Finisher.
•
When Puncher fails, output goes to the Sub Tray.
However, when booklet is selected, output goes to the Booklet.
•
The aim in changing the output to the Sub Tray based on the SheetDelivered receive
timing from the IOT is displayed in the Control Panel which displays "Copying" mes-
sage when the [Start] button is pressed, until the IOT stops.
Procedure
For case (1), please check that the same selected paper size has been set on the paper
tray.
For case (2), check that the error codes: 012-231, 012-232, 012-233 or 012-234 has been
displayed, and repair the specified Output Tray using the proper RAP.
Initial Issue
WorkCentre 5335 Family Service Documentation
124-709 Stapler Sheets Counts RAP
The No. of Stapler Sheets exceeded was detected but printing was continued.
Procedure
Ask customer to check the job setup.
07/2011
2-987
BUS Updated 12/2011
Status Indicator RAPs
124-708, 124-709
Advertisement
Table of Contents
