116-780 Attached Document Rap; 116-790 Stapling Canceled Rap (Integrated Finisher) - Xerox workcentre 5335 series Service Manual

116-780 Attached Document RAP

There was an error in the document attached to the E-mail to XXX.
Initial Actions
Power Off/On
Procedure
No action necessary.
Status Indicator RAPs
116-780, 116-790

116-790 Stapling Canceled RAP (Integrated Finisher)

BSD-ON: BSD 12.5 - Integrated Finisher Staple Control
When Staple was specified, there were no staples.
1. If the operator stops a FAX/Internet FAX Mailbox received documents print, cancel one of
the lead Stapler and print.
2. If 1. is not possible, cancel Stapler for all copy and print
Initial Actions
Power Off/On
Procedure
Execute Component Control
tridge. The display changes.
Y N
Check the Staple Cartridge for failure or foreign substances. There are no foreign sub-
stances and nothing has failed.
Y N
Repair the failure and remove the foreign substances.
Check the wires between
short circuit. The wires are OK.
Y N
Repair as required.
Measure the voltage between the Finisher PWB
age is approx. +5VDC.
Y N
Replace the Finisher PWB
Measure the voltage between the Finisher PWB P/J8701-7 (+) and GND (-). Install and
remove the Staple Cartridge. The voltage changes.
Y N
Replace the Finisher PWB
Replace the Staple Assembly
(PL 22.7).
Check the sw version of the controller sw - update if required. Replace the Finisher PWB
22.7) If the problem persists, replace the MCU PWB
07/2011
2-910
BUS Updated 12/2011
[012-242 Low Staple Sensor]. Install and remove the Staple Car-
P/J8731 and P/J8701 for a loose connection, or an open or a
P/J8701 -5 (+) and GND (-). The
(PL 22.7).
(PL 22.7).
(PL 22.4) If the problem persists, replace the Finisher PWB
(PL 18.2).
WorkCentre 5335 Family Service Documentation
volt-
(PL
Initial Issue