REP 10.10 Offset Motor
Parts List on
PL 17.1
Removal
1.
Switch off the power and disconnect the power cord.
2.
Remove the Exit 2 Assembly
REP
10.5.
NOTE: The Motor Cover Screw and the Offset Motor Screws are different than the other
screws, keep it with the cover and motor for re-installation.
3.
Remove the Motor Cover (1 Screw)
(Figure
3
Figure 1 Removing Screw
Initial Issue
WorkCentre 5335 Family Service Documentation
1).
BUS Updated 12/2011
4.
Perform the following
(Figure
2).
a.
Disconnect the Offset Motor PJ.
b.
Remove the Screws (2) and the Offset Motor.
a
Figure 2 Removing Screws & PJ
Replacement
1.
To install, carry out the removal steps in reverse order.
NOTE: Make sure the Ground Spring for the Offset Motor is captured by the mounting
screw when replacing the motor
Figure 3 Ground Spring
07/2011
4-91
b
(Figure
3).
Repairs & Adjustments
REP 10.10