Rep 12.10 Complier Exit Sensor - Xerox workcentre 5335 series Service Manual

Figure 4 Removing the Finisher Entrance Sensor
Replacement
1. Reverse the removal procedure for replacement.
Repairs & Adjustments
REP 12.9, REP 12.10
REP 12.10 Compiler Exit Sensor
Parts List on
Removal
1. Switch off the power and disconnect the power cord.
2. Remove the Integrated Office Finisher from the machine
3. Turn over the Integrated Office Finisher.
4. Remove the Bottom Cover
5. Remove the Connector Bracket
(1)Release Clamps (3) and remove the wire.
(2)Disconnect Connectors (5).
(3)Remove Screws (2).
(4)Remove Connector Bracket.
6. Remove the Bottom Plate
(1)Release Clamps (5) and remove the wire.
(2)Disconnect Connectors (8).
(3)Release Wire from Hook.
(4)Remove Screws (4).
(5)Remove Bottom Plate.
07/2011
4-106
BUS Updated 12/2011
PL 22.5
(PL 22.2)
(Figure 1):
Figure 1 Removing the Connector Bracket
(Figure 2):
WorkCentre 5335 Family Service Documentation
(REP 12.1).
Initial Issue