Rep 8.2 Tray 2 Feeder Assembly - Xerox workcentre 5335 series Service Manual

REP 8.2 Tray 2 Feeder Assembly

Parts List on PL 9.4
Removal
1. Switch off the Power and disconnect the power cord.
2. Remove Paper Tray 2:
a. Remove the paper from the tray.
b. Pull the tray open.
c. Lift up the front of the tray so the rollers clear the stops and remove the tray.
3. Remove the MSI REP 7.2.
4. Remove the Lower Left Hand Cover
a. Pull out the cap on the Locking Hinge Pin and remove the pin.
b. Raise the cover, then move the rear of the cover out and remove the cover from the
front pivot.
Pull out Cap
Figure 1 Removing Cover
NOTE: The harness cover screw has a different thread than the other screws, keep it with the
harness cover for re-installation.
5. Remove the harness cover (1 Screw)
Screw
Figure 2 Removing Screw
Initial Issue
WorkCentre 5335 Family Service Documentation
(Figure 1).
(Figure 2).
BUS Updated 12/2011
6. Perform the following (Figure 3).
a. Disconnect Feeder 2 P/Js (2) and release the harness from the clamp.
b. Remove the Pivot Bracket (1 Screw).
Screw
P/Js
Figure 3 Removing Screws & P/Js
7. Remove Feeder 2 (Figure 4).
a. Remove the screws (2).
b. First, slide out the front of the feeder, then remove it.
Replacement
1. To reinstall, carry out the removal steps in reverse order.
07/2011
4-63
Screws
Figure 4 Removal
Repairs & Adjustments
REP 8.2