Xerox workcentre 5335 series Service Manual page 1134

18. Remove the HVPS (Figure 16).
a. Release the wire harness from the clamp, and disconnect the connector.
b. Remove the Screws (2).
c. Pull the HVPS out.
b
a
Figure 16 Removing Screws
19. Perform the following (Figure 17).
a. Release the Xerographic Module Connector from the frame.
b. Remove the Cartridge Guide top Screws (2).
a
Figure 17 Removing Screws
Initial Issue
WorkCentre 5335 Family Service Documentation
b
BUS Updated 12/2011
20. Release the BTR Contact Cover from the frame (2 locking tabs)
21. Remove the Xerographic Cartridge Guide Assembly
a. Remove the left side Screws (2).
b. Remove the guide, routing the front and rear wire harnesses through the frame
openings.
Figure 19 Removing Screws
Replacement
1. To reinstall, carry out the removal steps in reverse order.
07/2011
4-73
(Figure 18).
20
Figure 18 Removal
(Figure 19).
b
a
Repairs & Adjustments
REP 9.1