075-135 Registration Sensor On Jam (Tray 4) Rap - Xerox workcentre 5335 series Service Manual

075-135 Registration Sensor On Jam (Tray 4) RAP

BSD-ON: BSD 4.1 - Main Drive Control
BSD-ON: BSD 7.9 - Tray 5 (MSI) Paper Stacking
BSD-ON: BSD 8.5 - Registration
The Registration Sensor does not turn ON within the specified time after the Registration
Clutch On after the Feed from the MSI has started.
NOTE: When turning the power OFF, turn OFF the power switch first and then the main power
switch.
Initial Actions
Check the following:
• A paper transportation failure due to a foreign substance/burr on the paper path
• The Registration Sensor for contamination, improper installation, and Actuator operation
failure
• The Takeaway Roll and Pinch Roll for contamination, wear, and revolution failure
• The Takeaway Roll Drive Gear for wear and damage
• Use of paper out of spec
Procedure
Check the following:
• The Registration Sensor for failure: Component Control
• The connection between the Registration Sensor
open circuit, short circuit, and poor contact
• The Main Drive Motor for revolution failure:
• The Registration Transport Assy (PL 15.1
Reload the machine software (GP 16). If no problems are found, replace the MCU PWB
18.2).
Initial Issue
WorkCentre 5335 Family Service Documentation
[077-104] (PL 15.1)
P/J121 and the MCU PWB P/J415
Component Control [042-003] CW (PL 3.2)
) for installation failure
BUS Updated 12/2011
for
(PL
07/2011
2-801
Status Indicator RAPs
075-135