7.
Remove the Toner Cartridge Connector
a.
Disconnect the PJ (1).
b.
Remove Connector (1 Screw).
c.
Release the wire harness from the front clamps and left side of the Cartridge Guide.
c
Figure 6 Wires & PJ
8.
Remove the Toner Cartridge Guide
(Figure
a.
On the left rear of the guide, remove the Dispenser Tube Screw (1).
b.
Loosen the front Screws (2).
c.
Lift the front of the guide up and remove it.
a
Figure 7 Removing The Screws
Initial Issue
WorkCentre 5335 Family Service Documentation
(Figure
6).
a
b
7).
b
BUS Updated 12/2011
9.
Remove the Toner Dispense Motor
NOTE: The 4 motor screws are longer then the other screws, keep them with the motor
for reinstallation.
a.
Disconnect the PJ (1).
b.
Remove the Screws (4), and the Motor.
Figure 8 Removing The Motor
Replacement
1.
To reinstall, carry out the removal steps in reverse order.
07/2011
4-79
(Figure
8).
a
b
Repairs & Adjustments
REP 9.6