Xerox workcentre 5335 series Service Manual page 1123

7. Remove Feeder 1 Chute (Figure 4).
Figure 4 Chute
8. Remove the Takeaway Chute (Figure
NOTE: Make note of how the Sensor Wires are routed through the retainers on the chute
to avoid pinching the wires when reinstalling the chute.
a. Remove the Screws (2).
b. Release the Tab, and remove the chute.
Figure 5 Removing Screws
Repairs & Adjustments
REP 8.1
Chute
5).
Screws
Tab
BUS Updated 12/2011
9. Perform the following (Figure
a. Disconnect Feeder 1 P/Js (2).
b. Loosen the harness bracket, remove the Screws (3).
Figure 6 Removing Screws & P/Js
10. Remove Feeder 1 (Figure 7).
a. Remove the Screws (2).
b. First, slide out the front of the feeder; then remove it.
Figure 7 Removing Screws
Replacement
1. To reinstall, carry out the removal steps in reverse order.
07/2011
4-62
6).
Screws
P/Js
Screws
WorkCentre 5335 Family Service Documentation
Initial Issue