016-724 Staple Position Rap; 016-725 B-Formatter Image Rap - Xerox workcentre 5335 series Service Manual

016-724 Staple Position RAP

The staple selection and hole punch selection is not compatible.
Initial Actions
Ensure the staple position selection and hole punch position selection is compatible (no holes
will be punched on staples or staples located in holes)
Procedure
• Change settings so that the same blinding position (same side of output paper) is speci-
fied.
• Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
• Check the sw version of the controller sw - update if required
Initial Issue
WorkCentre 5335 Family Service Documentation

016-725 B-Formatter Image RAP

BSD-ON: BSD 34.1 - FAX
An error has occurred in the B-Formatter during the image conversion of scanned document to
Fax sending document. An error has occurred where the Mailbox document cannot be con-
verted to Facsimile Data when Job Flow function of the machine is used to send the scanned
documents stored in the Mailbox to the Facsimile Device
Initial Actions
Power Off/On
Procedure
• Do not use the Job Flow function.
• On the Facsimile selection screen of the machine, specify to directly scan the document
and send it to the Facsimile recipient.
• Check the sw version of the controller sw - update if required
• If the problem persists, replace the ESS PWB
07/2011
2-241
BUS Updated 12/2011
(PL 35.2).
Status Indicator RAPs
016-724, 016-725