Rep 5.13 Dadf Feed Motor - Xerox workcentre 5335 series Service Manual

Figure 2 Belt Installation
Repairs & Adjustments
REP 5.12, REP 5.13

REP 5.13 DADF Feed Motor

Parts List on
Removal
1. Switch off the power and disconnect the power cord.
2. Remove the DADF Front Cover.
3. Remove the DADF Rear Cover.
4. Remove the DADF.
5. Remove the DADF Document Tray.
6. Remove the DADF Feeder Assembly.
7. Remove the Registration Chute.
8. Remove the Top Cover.
9. Remove the Harness Guide and the wire harness.
10. Turn the DADF Feeder Assembly upside down.
11. Remove the DADF Feed Motor.
(1) Remove the spring.
(2) Remove the screws (x2).
(3) Remove the DADF Feed Motor.
Replacement
1. To install, carry out the removal steps in reverse order.
2. Install the Belt to the Pulley of the DADF Feed Motor.
07/2011
4-26
BUS Updated 12/2011
PL 51.5
(REP 5.3)
(REP 5.4)
(REP 5.1)
(REP 5.9)
(REP 5.5)
(REP 5.14)
(REP 5.10)
(REP
(Figure 1)
Figure 1 DADF Feed Motor Removal
(Figure
WorkCentre 5335 Family Service Documentation
5.11)
2)
Initial Issue