016-947 APS No Destination Error RAP
The system detected that no tray is loaded with paper for Auto Paper Selection after the
job for which the paper for APS (Auto Paper Selection) was selected or APS was set has
started.
Procedure
•
Specify the job to avoid the detection conditions.
•
Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
•
Check the sw version of the controller sw - update if required
Status Indicator RAPs
016-947, 016-948
016-948 Small Book Action NG RAP
The covers with images, separators, or blank pages were detected after the job had
started with Booklet specified.
Procedure
•
Specify the job to avoid the detection conditions.
•
Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
•
Check the sw version of the controller sw - update if required
(GP
16)
07/2011
2-284
BUS Updated 12/2011
(GP
16)
Initial Issue
WorkCentre 5335 Family Service Documentation