016-752 PDF Memory Limit RAP
Insufficient memory was detected during PDF Bridge processing.
Initial Actions
Power Off/On
Procedure
•
When the Print mode is set to [High Quality], change the setting to [Normal]. When the
Print mode is set to [Standard], change the setting to [High Speed]. (Only for the machine
with High Quality mode.)
•
Expand the memory capacity.
•
If the problem persists after expanding to the maximum capacity, print using a driver from
Acrobat Reader.
•
Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
•
Check the sw version of the controller sw - update if required
Initial Issue
WorkCentre 5335 Family Service Documentation
016-753 PDF PassWord Mismatch RAP
PDF Password Mismatched. The password specified on the UI panel and the password speci-
fied in XJPL (specified by the contents bridge) did not agree when processing a PDF file that
was password protected.
Procedure
•
Specify the correct password on UI Panel or through Contents Bridge.
•
Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
•
Check the sw version of the controller sw - update if required
07/2011
2-255
BUS Updated 12/2011
Status Indicator RAPs
016-752, 016-753