077-101 Registration Sensor Off Jam RAP
BSD-ON:
BSD 4.1 - Main Drive Control
BSD-ON:
BSD 7.9 - Tray 5 (MSI) Paper Stacking
BSD-ON:
BSD 8.5 - Registration
BSD-ON:
BSD 9.5 Drum Drive Control
The Registration Sensor does not turn OFF within the specified time after the Registration
Clutch On.
NOTE: When turning the power OFF, turn OFF the power switch first and then the main power
switch.
Initial Actions
Check the following:
•
A paper transportation failure due to a foreign substance/burr on the paper path
•
Each Takeaway Roll and Pinch Roll for contamination, wear, and revolution failure
•
The Registration Roll and Pinch Roll for contamination, wear, and revolution failure
•
Each Exit Roll and Pinch Roll for contamination, wear, and revolution failure
•
Each Takeaway Roll Drive Gear for wear and damage
•
The Registration Roll Drive Gear for wear and damage
•
The BTR for contamination, wear, and revolution failure
•
The Fuser Drive Gear for wear and damage
•
Each Exit Roll Drive Gear for wear and damage
•
Use of paper out of spec
•
The Registration Sensor for contamination, improper installation, and Actuator operation
failure
Procedure
Check the following:
•
The Registration Sensor for failure:
Component Control
•
The Registration Clutch for failure:
Component Control
•
The Main Drive Motor for revolution failure:
•
The Takeaway Clutch for failure:
Component Control
•
The Registration Transport Assy
(PL
Reload the machine software
(GP
16). If no problems are found, replace the MCU PWB
18.2).
Initial Issue
WorkCentre 5335 Family Service Documentation
[077-104]
(PL
15.1)
[077-002]
(PL
15.1)
Component Control
[042-003] CW
(PL
[077-001]
(PL
15.1)
15.1) for installation failure
BUS Updated 12/2011
077-103 Exit Sensor 1 Off Jam RAP
BSD-ON:
BSD 10.2 - Fusing
BSD-ON:
BSD 10.4 - Exit 2 Drive
After the Fuser Exit Sensor turned ON, the Fuser Exit Sensor did not turn OFF within the spec-
ified time.
NOTE: When turning the power OFF, turn OFF the power switch first and then the main power
switch.
Initial Actions
Check the following:
•
A paper transportation failure due to a foreign substance/burr on the paper path
•
The Fuser for wound up, stuck paper
•
The Fuser Exit Sensor for contamination, improper installation, and Actuator operation
failure
•
Each Exit Roll and Pinch Roll for contamination, wear, and revolution failure
•
Each Exit Roll Drive Gear for wear and damage
•
The Exit 1 Gate for operation failure
•
Use of paper out of spec
Procedure
Check the following:
•
The Fuser Exit Sensor for failure:
•
The Exit 2 Motor for revolution failure:
•
The Exit Gate Solenoid for failure:
Reload the machine software
18.2).
3.2)
(PL
07/2011
2-803
Component Control
[077-101]
(PL
Component Control
[077-015]
Component Control
[077-004]
(PL
(GP
16). If no problems are found, replace the MCU PWB
Status Indicator RAPs
077-101, 077-103
7.1)
(PL
17.5)
17.5)
(PL