Rep 9.1 Xerographic Cartridge Guide Assembly - Xerox workcentre 5335 series Service Manual

REP 9.1 Xerographic Cartridge Guide Assembly

Parts List on PL 8.2
Removal
1. Switch off the power and disconnect the power cord.
2. Remove the MSI Assembly REP 7.2.
3. Perform the following (Figure 1).
a. Open the Left Hand Cover.
b. Disconnect PJ409 on the MCU PWB, and release the wire harness from the clamps
b
Figure 1 PJ
NOTE: Support the Left Hand Cover Assembly when releasing the supports to prevent damag-
ing the cover.
4. Remove the Left Hand Cover Assembly
a. Twist the Front Support and remove it from the slot.
b. Remove the K-Clip, and remove the Rear Support from the pin.
c. Move the cover down to a horizontal position, then lift it off the pivots.
Initial Issue
WorkCentre 5335 Family Service Documentation
a
(Figure 2).
BUS Updated 12/2011
b
Figure 2 Left Hand Cover
5. Disconnect the connectors on the Top and Right side of the MCU PWB, and release the
wire harnesses from the clamps
07/2011
4-69
a
c
(Figure 3).
Figure 3 PJ's
Repairs & Adjustments
REP 9.1