Table of Contents
Advertisement
016-786 HD Full-Scan Write Error RAP
HD Full-Scan Write Error. It was not possible to write a file while using the scan function
because the HDD capacity was insufficient.
Procedure
1.
Turn the machine OFF then ON.
2.
If no paper remains in the tray of this machine, replenish the paper.
3.
If this occurs when sending e-mail, take any one of the following actions:
–
Reduce the resolution and re-send it.
–
Reduce the size and re-send it.
–
Reduce the number of pages and separate the job into several batches when send-
ing.
–
Set [Output Color] to [Black] and re-send it.
4.
A print job may make HDD full for a while, so wait for a while and retry.
5.
Perform
GP 14
- only the first two parts - make sure to follow sequence and heed cau-
tions
a.
Job Log Clear Mode
b.
HDD Initialize Mode
6.
Initialize Hard
Disk.
7.
Disconnect then reconnect the HDD, ESS, MCU all PWBs connected to them (RAM,
Firmware module, EEPROM)
8.
Check the sw version of the controller sw. Reload software.
9.
Replace ESS PWB
(PL
35.2) (If not fixed by this, reinstall the original ESS PWB and RAM
DIMM.)
Status Indicator RAPs
016-786, 016-787
016-787 Invalid Server IP ADD RAP
[JT Syntax Error during Scanning]
This is a syntax error in the Job Template during Scan to FTP operation and limited to the
following cases (because of Redirector detection):
Incorrect Server IP Address (IP Syntax Error)
A text with incorrect format has been entered as the IP address for Job Template settings.
Procedure
Specify the correct Job Template.
1.
Check the settings of Job Template.
07/2011
2-272
BUS Updated 12/2011
Initial Issue
WorkCentre 5335 Family Service Documentation
Advertisement
Table of Contents
