Rep 12.16 Stacker Tray Assembly - Xerox workcentre 5335 series Service Manual

REP 12.16 Stacker Tray Assembly

Parts List on PL 22.8
Removal
1. Switch off the power and disconnect the power cord.
2. Remove the Integrated Office Finisher from the machine
3. Remove the Inner Front Cover (PL 22.1)
4. Remove the Rear Cover (PL 22.1)
5. Turn over the Integrated Office Finisher.
6. Remove the Bottom Cover (PL 22.2)
7. Remove the Tray Cover (PL 22.2)
8. Disconnect Connector (Figure 1):
(1)Release Clamp.
(2)Remove Clamp.
(3)Release and remove Wire from Hook.
(4)Release Clamp.
(5)Disconnect Connector.
(6)Release and remove Wire from Hook.
Figure 1 Disconnecting the Connector
9. Release the Clamps and the Hook to remove the wire
(1)Release Clamps (5).
(2)Remove Wire from Hook.
Repairs & Adjustments
REP 12.16
(REP 12.1).
10. Remove the Stacker Sensor Assembly
(Figure 2):
11. Remove the Stacker Tray Assembly
07/2011
4-116
BUS Updated 12/2011
Figure 2 Disconnecting the Wire
(Figure
(1)Remove Screw.
(2)Remove Stacker Sensor Assembly.
(3)Release Clamps (4).
(4)Disconnect Connectors (2).
Figure 3 Removing the Stacker Sensor Assembly
(Figure
(1)Remove Screws (5).
(2)Remove Stacker Tray Assembly.
WorkCentre 5335 Family Service Documentation
3):
4):
Initial Issue