121-339 Price Table Error Rap; 121-340 Ep Accessory Miss Match Rap - Xerox workcentre 5335 series Service Manual

121-339 Price Table Error RAP

BSD-ON: BSD 3.7 - ESS-FDI Communication
System Fail. Unit price table error. Detection Condition (1): When the M/C is running, a notifica-
tion is issued from the Coin Kit indicating that the price data in the Coin Kit has been changed.
Detection Condition (2): When the M/C is booting or returning from Power Save, a notification
is issued from the Coin Kit indicating a unit price error. (The unit price table in the Coin Kit con-
tains unset unit price(s)).
Procedure
• Detection Condition (1): Turn the power OFF then ON.
Detection Condition (2): Correct the unit price settings in the Coin Kit, and then turn the
power OFF then ON.
• Ensure that the customer is programming a job within the parameters of the machine uti-
lizing the UI.
• Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
• Check the sw version of the controller sw - update if required
• Replace RAM DIMM on ESS PWB (PL
• Replace ESS PWB (PL 35.2) (If not fixed by this, reinstall the original ESS PWB and RAM
DIMM)
Initial Issue
WorkCentre 5335 Family Service Documentation
35.2)
BUS Updated 12/2011

121-340 EP Accessory Miss Match RAP

BSD-ON: BSD 3.7 - ESS-FDI Communication
System Fail. FDI - Accessories Form Mismatch. The combination of accessories that are
installed does not match the specifications.
Procedure
• Checks whether they are installed correctly against the specifications.
If they are installed correctly, turn the power OFF then ON. If the problem persists, per-
form the following procedure to repair it.
• Check the sw version of the controller sw - update if required
• Reinstall or replace the FDI.
• Ensure that the customer is programming a job within the parameters of the machine uti-
lizing the UI.
• Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
• Replace RAM DIMM on ESS PWB
• Replace ESS PWB (PL 35.2) (If not fixed by this, reinstall the original ESS PWB and RAM
DIMM)
07/2011
2-923
(PL 35.2)
Status Indicator RAPs
121-339, 121-340