Rep 12.9 Finisher Entrance Sensor - Xerox workcentre 5335 series Service Manual

REP 12.9 Finisher Entrance Sensor

Parts List on PL 22.5
Removal
1. Switch off the power and disconnect the power cord.
2. Remove the Integrated Office Finisher from the machine
3. Turn over the Integrated Office Finisher.
4. Remove the Bottom Cover (PL 22.2)
5. Remove the Connector Bracket (Figure
(1)Release Clamps (3) and remove the wire.
(2)Disconnect Connectors (5).
(3)Remove Screws (2).
(4)Remove Connector Bracket.
Figure 1 Removing the Connector Bracket
6. Remove the Bottom Plate (Figure 2):
(1)Release Clamps (5) and remove the wire.
(2)Disconnect Connectors (8).
(3)Remove Wire from Hook.
(4)Remove Screws (4).
(5)Remove Bottom Plate.
Initial Issue
WorkCentre 5335 Family Service Documentation
(REP 12.1).
1):
BUS Updated 12/2011
Figure 2 Removing the Bottom Plate
7. Remove the Finisher Entrance Sensor Assembly
(1)Disconnect Connector.
(2)Remove Self-tapping Screw.
(3)Remove Finisher Entrance Sensor Assembly.
Figure 3 Removing the Finisher Entrance Sensor Assembly
8. Remove the Finisher Entrance Sensor
(1)Remove Finisher Entrance Sensor from Bracket.
07/2011
4-105
(Figure 3):
(Figure 4):
Repairs & Adjustments
REP 12.9