024-361 Invalid IOT Paper Size RAP
BSD-ON:
BSD 3.1 - ESS - MCU Communication
BSD-ON:
BSD 16.1 - ESS
Invalid IOT Paper Size Group Information.
Initial Actions
Power Off/On
Procedure
•
Ensure that the customer is programming a job within the parameters of the machine uti-
lizing the UI.
•
Check that connectors on the MCU PWB MCU PWB
35.2) are securely connected. Disconnect then reconnect the IIT, Control Panel, ESS,
MCU all PWBs connected to them (RAM, Firmware module, EEPROM)
•
Check the sw version of the controller sw. If the problem continues, reload Software
16).
•
Replace ESS PWB
(PL
35.2) (If not fixed by this, reinstall the original ESS & MCU)
•
If the problem persists, replace the MCU PWB MCU PWB
Initial Issue
WorkCentre 5335 Family Service Documentation
024-362 Page Sync Start RAP
BSD-ON:
BSD-ON:
During IOT output, before the output data was written to FIFO Full (first in first out), Page Sync
activated.
Initial Actions
Power Off/On
Procedure
•
(PL
18.2) and on the ESS PWB
(PL
•
(GP
•
•
(PL
18.2)
•
07/2011
2-387
BUS Updated 12/2011
BSD 3.1 - ESS - MCU Communication
BSD 16.1 - ESS
Ensure that the customer is programming a job within the parameters of the machine uti-
lizing the UI.
Check that connectors on the MCU PWB MCU PWB
35.2) are securely connected. Disconnect then reconnect the IIT, Control Panel, ESS,
MCU all PWBs connected to them (RAM, Firmware module, EEPROM)
Check the sw version of the controller sw. If the problem continues, reload Software
16).
Replace ESS PWB
(PL
35.2) (If not fixed by this, reinstall the original ESS & MCU)
If the problem persists, replace the MCU PWB MCU PWB
(PL
18.2) and on the ESS PWB
(PL
(GP
(PL
18.2)
Status Indicator RAPs
024-361, 024-362