024-928 (Integrated Office Finisher) Scratch Sheet Compile Rap; 024-928 (Finisher Lx) Scratch Sheet Compile Rap - Xerox workcentre 5335 series Service Manual

024-928 (Integrated Office Finisher) Scratch Sheet Compile
RAP
Paper was detected that was either out of spec, in poor condition (wrinkled, curled) and was
ejected to the compiler.
NOTE: This code is an operation message. If this code is frequently declared, perform the pro-
cedure below.
Initial Actions
• Check that the Top Cover can be opened and closed.
• Power Off/On.
Procedure
Check the specifications of paper. The paper is in spec.
Y N
Replace the paper with new paper that is in spec.
Check the condition of the paper. The paper is in normal condition without any problem
that causes the paper to be bent (dog eared) or jam.
Y N
Resolve any problem that causes the paper to be bent or caught.
Check for a Fault Code. Another Fault Code is displayed.
Y N
If the problem continues, replace the Finisher PWB
Go to the appropriate Fault Code.
Status Indicator RAPs
024-928 (Integrated Office Finisher), 024-928 (Finish-
(PL 22.7).
07/2011
2-410
BUS Updated 12/2011

024-928 (Finisher LX) Scratch Sheet Compile RAP

A sheet, which is identified as an abnormal sheet (scratch sheet) by Sheet Exit command from
IOT, is ejected to the Compiler Tray.
Initial Actions
Ensure that the Eject cover is closed.
Procedure
Check all connectors on the Finisher PWB. The connectors are connected correctly.
Y N
Connect the connectors.
Switch the power Off then On. Open and close the Eject Cover. If the fault is still present,
replace the Finisher PWB (PL 22.7).
Initial Issue
WorkCentre 5335 Family Service Documentation