116-372 Formatter RAP
An internal shutdown occurred after a processing error.
Initial Actions
Power Off/On
Procedure
•
Remove and re-install or replace the System Memory and Page Memory DIMMs
35.2).
•
Ensure that the customer is programming a job within the parameters of the machine uti-
lizing the UI.
•
Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
•
Check the sw version of the controller sw - update if required
•
Replace RAM DIMM on ESS PWB
(PL
•
Replace ESS PWB
(PL
35.2) (If not fixed by this, reinstall the original ESS PWB)
Initial Issue
WorkCentre 5335 Family Service Documentation
35.2)
BUS Updated 12/2011
116-373 Dynamic DNS Software RAP
An internal shutdown occurred after a DDNS (Dynamic Domain Name System) processing
error.
Initial Actions
Power Off/On
Procedure
(PL
•
Change the system data 700-530 to "0" and disable the automatic startup boot operation
at SystemFail (make sure to reset to 1 when complete
•
Remove and re-install or replace the System Memory and Page Memory DIMMs
35.2).
•
Specially check for faulty ports or Net connection. Check which of the following ports is
faulty.
–
SNTP
–
NetWare
–
Salutation IO
–
SMB
–
Port 9100
–
USB
–
lpd
–
FTP Serv
–
MailIO
–
IPP
–
Check the sw version of the controller sw - update if required
–
Replace ESS PWB
(PL
07/2011
2-875
35.2) (If not fixed by this, reinstall the original ESS PWB)
Status Indicator RAPs
116-372, 116-373
(PL