Xerox workcentre 5335 series Service Manual page 1099

9. Remove the ROS Cover (Figure 8).
a. Remove the Screws (2) on the left side of the cover.
b. Remove the top Screw (1).
c. Move the cover to the left and remove it.
a
Figure 8 Removing Screws
10. Disconnect the ROS PJ's (4) and release the wire harness from the clamps
Figure 9 PJ's
Repairs & Adjustments
REP 6.2
c
b
(Figure
10
BUS Updated 12/2011
Do not touch the ROS window when holding it.
NOTE: The ROS screws are longer then the other screws, keep them with the ROS for rein-
stallation.
11. Remove the ROS (Figure
a. Remove the Screws (5).
b. Remove the ROS.
9).
Replacement
NOTE: When reinstalling the ROS be sure to seat the ROS into the two locating holes in the
machine frame.
1. To install, carry out the removal steps in reverse order.
07/2011
4-38
CAUTION
10).
a
Figure 10 Removing Screws
WorkCentre 5335 Family Service Documentation
Initial Issue