024-980 Stacker Tray Full Rap; 024-982 Finisher Stacker Tray Lower Safety Rap - Xerox workcentre 5335 series Service Manual

024-980 Stacker Tray Full RAP

BSD-ON: BSD 12.24 - Office Finisher LX Stacker Tray Control
The output paper stacked on the Finisher Stacker Tray reaches capacity (for mixed paper size).
There are a number of different conditions that can cause this fault and those conditions differ
for the different finishers.
Initial Actions
• Remove the paper from the Stacker Tray
• Power Off/On
Procedure
• Go to the 012-211 (Integrated Finisher)
• Remove the paper from the Stacker Tray
• Check the Stack Height Sensor 1 Component Control
the sensor, and Stack Height Sensor 2
• Check the wiring for an open or short circuit repair as required.
• Check the sw version of the controller sw - update if required
• Replace the defective Sensor (PL 23.11).
• If the fault is still occurring replace the Finisher PWB
• Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
Status Indicator RAPs
024-980, 024-982
RAP.
[012-264] and block and unblock
Component Control [012-265].
(PL 23.16).
BUS Updated 12/2011

024-982 Finisher Stacker Tray Lower Safety RAP

BSD-ON: BSD 12.24 - Office Finisher LX Stacker Tray Control
Stacker tray moved down past the lower limit position.
Initial Actions
Power Off/On
Procedure
• Go to 012-213 Stacker Tray Lower Limit Failure RAP (LX),
Stack Tray Fail.
• Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
• Check the sw version of the controller sw - update if required
07/2011
2-426
012-211 (Integrated Finisher)
(GP 16)
Initial Issue
WorkCentre 5335 Family Service Documentation