016-706 Maximum Users Exceeded RAP
The system detected that a job exceeded the maximum no. of users for Secure and Sample
Prints and aborted the job. FULL status was detected at HD access and a job was aborted
Initial Actions
Power Off/On
Procedure
•
Delete unnecessary documents/users and print again.
•
Refer customer to User Guide headings Maximum Stored Pages,
•
Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
•
Check the sw version of the controller sw - update if required
Status Indicator RAPs
016-706, 016-707
016-707 Sample Print RAP
Proof Print Registration failed because it cannot be stored without a HD.
Initial Actions
Power Off/On
Procedure
If the problem occurred at installation, check whether the operations for Proof Print are correct.
•
Disconnect then reconnect the HDD, ESS, MCU all PWBs connected to them (RAM,
Firmware module, EEPROM)
•
Check the sw version of the controller sw - update if required
•
Perform
tions
1.
Job Log Clear Mode
2.
HDD Initialize Mode
•
Replace HDD
•
Replace ESS PWB
DIMM.)
07/2011
2-232
BUS Updated 12/2011
GP 14
- only the first two parts - make sure to follow sequence and heed cau-
(PL
35.2)
(PL
35.2) (If not fixed by this, reinstall the original ESS PWB and RAM
WorkCentre 5335 Family Service Documentation
Initial Issue