Rep 10.1 Duplex Motor - Xerox workcentre 5335 series Service Manual

REP 10.1 Duplex Motor

Parts List on PL 14.4
Removal
1. Switch off the power and disconnect the power cord.
2. Open the Left Hand Cover (Figure 1).
a. Release the front and rear locking tabs and remove the BTR Assembly.
Figure 1 Removal
3. Remove the Left Hand Chute Cover (4 Screws)
Figure 2 Removing Screws
Initial Issue
WorkCentre 5335 Family Service Documentation
a
(Figure 2).
3
07/2011
BUS Updated 12/2011
4. Remove the Left Hand Cover (7 Screws)
NOTE: The Left Hand Cover Screws have a different thread than the other screws, keep
them with the cover for re-installation.
Figure 3 Removing Screws
5. Perform the following (Figure 4).
a. Disconnect the PJ from the Duplex Motor.
b. Remove the Harness Guide; loosen the top screw, remove the bottom screw.
b
Figure 4 Removing Screws
4-81
(Figure 3).
4
a
Repairs & Adjustments
REP 10.1