Table of Contents
Advertisement
116-210 Media Reader Fatal Error RAP
When this error is detected in OSDD.
Initial Actions
Power Off/On
Procedure
1.
Power Off
2.
Check/Replace the following:
a.
Media Reader
(PL
35.2). Check: Media Reader communication P/J343.
b.
Check +5VDC to ESS
(+5VDC Power
3.
Ensure that the customer is programming a job within the parameters of the machine uti-
lizing the UI.
4.
Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
5.
Check the sw version of the controller sw - update if required
6.
Replace RAM DIMM on ESS PWB
(PL
7.
Replace ESS PWB
(PL
35.2) (If not fixed by this, reinstall the original ESS PWB)
Initial Issue
WorkCentre 5335 Family Service Documentation
RAP).
35.2)
BUS Updated 12/2011
116-211 MediaReader Cable Disconnected RAP
Service Fail. [Media Reader] Connection Cable Disconnected. This error was detected in the
OSDD.
Procedure
1.
Check the USB Cable connection with the power OFF. If the problem persists, refer to the
following to repair it.
2.
Ensure that the customer is programming a job within the parameters of the machine uti-
lizing the UI.
3.
Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
4.
Check the sw version of the controller sw - update if required
5.
Replace RAM DIMM on ESS PWB
6.
Replace ESS PWB
(PL
35.2) (If not fixed by this, reinstall the original ESS PWB)
07/2011
2-847
(PL
35.2)
Status Indicator RAPs
116-210, 116-211
Advertisement
Table of Contents
