035-723 No CD after Receiving Flag RAP
BSD-ON:
BSD 34.1 - FAX
The Fax controller could not receive the CD (Collision Detection) signal within 3mins after
receiving the signal from the receiving Fax.
Procedure
•
There is a problem with the receiving Fax. Ask customer to cancel the job and resend.
•
Check the remote machine settings and line status, then perform the operation again.
•
Check the Fax line connection (telephone line).
•
Ensure that the customer is programming a job within the parameters of the machine uti-
lizing the UI.
•
Disconnect then reconnect the PWBs in the FAX Module
•
Check the sw version of the fax & controller sw - update if required
•
Perform FAX Diagnostic
GP 13
•
Replace the FAX PWB
(PL
18.5).
Initial Issue
WorkCentre 5335 Family Service Documentation
035-724 DCN Receive after Sending FTT RAP
BSD-ON:
BSD 34.1 - FAX
•
DCN was received after FTT had been sent. Sending machine failure. Poor line quality.
•
DCN was received.
Procedure
•
There is a problem with the receiving Fax. Ask customer to cancel the job and resend.
•
Check the remote machine settings and line status, then perform the operation again.
•
Check the Fax line connection (telephone line).
•
Ensure that the customer is programming a job within the parameters of the machine uti-
lizing the UI.
•
Disconnect then reconnect the PWBs in the FAX Module
•
Check the sw version of the fax & controller sw - update if required
•
Perform FAX Diagnostic
•
Replace the FAX PWB
07/2011
2-661
BUS Updated 12/2011
GP 13
(PL
18.5).
035-723, 035-724
Status Indicator RAPs