Table of Contents
Advertisement
074-212 Tray 4 Paper Size Sensor Broken RAP
BSD-ON:
BSD 7.4 - Tray 4 Paper Size Sensing (TTM)
Abnormal output AD value from Tray 4 Size Sensor was detected.
NOTE: When turning the power OFF, turn OFF the power switch first and then the main power
switch.
Procedure
Check the following:
•
Broken link and breakage at the bottom of the tray
•
The Actuator at the rear of the Tray for operation failure
•
The Tray 4 Paper Size Switch for failure:
[074-104]
(PL
11.12)
•
The connection between the Tray 4 Paper Size Sensor
PWB
P/J548
for open circuit, short circuit, and poor contact
Reload the machine software
(GP
16). If no problems are found, replace the Tray Module PWB
(PL
11.13).
Status Indicator RAPs
074-212, 074-900
Analog Monitor [074-200];Component Control
P/J103
and the Tray Module
BUS Updated 12/2011
074-900 Tray 4 Feed Out Sensor Static Jam RAP
BSD-ON:
BSD 8.3 - Paper Transportation (Tandem Tray Module)
When the power was turned ON, the M/C was stopped (Cycle Down/ Shut Down), or when the
interlocks were closed (all interlocks including options), the Tray 4 Feed Out Sensor detected
paper.
NOTE: When turning the power OFF, turn OFF the power switch first and then the main power
switch.
Procedure
Check the following:
•
The Tray 4 Feed Out Sensor
return failure, or improper installation
•
The Tray 4 Feed Out Sensor for failure:
•
The connection between the Tray 4 Feed Out Sensor P/J116-2 and the Tray Module
PWB P/J548-A2 for short circuit
Reload the machine software
(GP
16). If no problems are found, replace the Tray Module PWB
(PL
11.13).
07/2011
2-800
(PL
11.7) for remaining paper, contamination, Actuator
Component Control
[073-100]
(PL
WorkCentre 5335 Family Service Documentation
11.7)
Initial Issue
Advertisement
Table of Contents
