Xerox workcentre 5335 series Service Manual page 1153

NOTE: Support the Left Hand Cover Assembly when releasing the supports to prevent damag-
ing the cover.
4. Remove the Left Hand Cover Assembly
a. Twist the Front Support and remove it from the slot.
b. Remove the K-Clip, and remove the Rear Support from the pin.
c. Move the cover down to a horizontal position, then lift it off the pivots.
b
Figure 2 Left Hand Cover Removal
NOTE: Support the Registration Transport when removing it to avoid damaging the wire har-
ness connectors.
5. Perform the following (Figure 3).
a. Remove the transport Screws (2).
b. Move the Front of the transport out of the slot and move the transport out.
Initial Issue
WorkCentre 5335 Family Service Documentation
(Figure 2).
a
c
BUS Updated 12/2011
Figure 3 Removing Screws
6. Remove the Registration Transport
a. Release the wires from the clamps.
b. Disconnect the Registration Transport PJ's (2), and remove the transport.
Replacement
1. To install, carry out the removal steps in reverse order.
07/2011
4-93
b
a
(Figure 4).
b
a
Figure 4 PJ's
Repairs & Adjustments
REP 10.12