Table of Contents
Advertisement
071-100Tray 1 Pre Misfeed RAP
BSD-ON:
BSD 7.5 - Tray 1 Paper Stacking
BSD-ON:
BSD 8.1 - Trays 1~5 Paper Feeding
Tray1 Pre Feed Sensor is not turned ON by the paper in specified time from Tray1 Feed Start.
Initial Actions
•
A paper transportation failure due to a foreign substance/burr on the paper path
•
The Tray 1 Feed Roll, Retard Roll, and Nudger Roll for contamination, wear, and revolu-
tion failure (when the jam has occurred during Feed from Tray 1)
•
Use of paper out of spec
•
The Tray 1 Pre Feed Sensor for contamination, improper installation, and Actuator opera-
tion failure
Procedure
Check the following:
•
The Tray 1 Pre Feed Sensor for failure:
•
The Tray 1 Feed/Lift Motor failure:
Component Control
•
The connection between the Tray 1 Pre Feed Sensor
for open circuit, short circuit, and poor contact
Reload the machine software
(GP
16). If no problems are found, replace the MCU PWB
18.2).
Initial Issue
WorkCentre 5335 Family Service Documentation
Component Control
[071-105]
(PL
9.5)
[071-003] CW
(PL
9.6)
P/J107
and the MCU PWB
BUS Updated 12/2011
071-105 Registration Sensor On Jam (Tray 1) RAP
BSD-ON:
BSD 4.1 - Main Drive Control
BSD-ON:
BSD 7.5 - Tray 1 Paper Stacking
BSD-ON:
BSD 8.5 - Registration
The Registration Sensor does not turn ON within the specified time after the Registration
Clutch On after the Feed from Tray 1 has started.
NOTE: When turning the power OFF, turn OFF the power switch first and then the main power
switch.
Initial Actions
•
A paper transportation failure due to a foreign substance/burr on the paper path
•
The Tray 1 Feed Roll, Retard Roll, and Nudger Roll for contamination, wear, and revolu-
tion failure (when the jam has occurred during Feed from Tray 1)
•
Use of paper out of spec
•
The Registration Sensor for contamination, improper installation, and Actuator operation
failure
Procedure
P/J410
Check the following:
(PL
•
The Registration Sensor for failure:
•
The connection between the Registration Sensor
open circuit, short circuit, and poor contact
•
The Main Drive Motor for revolution failure:
Reload the machine software
18.2).
07/2011
2-787
Component Control
[077-104]
(PL
P/J121
and the MCU PWB
Component Control
[042-003] CW
(GP
16). If no problems are found, replace the MCU PWB
Status Indicator RAPs
071-100, 071-105
15.1)
P/J415
for
(PL
3.2)
(PL
Advertisement
Table of Contents
