Table of Contents
Advertisement
077-130 Registration Sensor On Jam (Duplex Direct) RAP
BSD-ON:
BSD 4.1 - Main Drive Control
BSD-ON:
BSD 8.5 - Registration
BSD-ON:
BSD 10. 5 - Duplex
The Registration Sensor does not turn ON within the specified time after the Registration
Clutch On after the Feed has started in Duplex Direct mode.
NOTE: When turning the power OFF, turn OFF the power switch first and then the main power
switch.
Procedure
Check the following:
•
A paper transportation failure due to a foreign substance/burr on the paper path
•
Each Duplex Roll and Pinch Roll for contamination, wear, and revolution failure
•
Each Duplex Roll Drive Gear for wear and damage
•
Use of paper out of spec
•
The Registration Sensor for contamination, improper installation, and Actuator operation
failure
Reload the machine software
(GP
16). If no problems are found, replace the MCU PWB
18.2).
Status Indicator RAPs
077-130, 077-131
077-131 Duplex Sensor On Jam RAP
BSD-ON:
BSD 8.5 - Registration
BSD-ON:
BSD 10. 5 - Duplex
The Duplex Sensor does not turn ON within the specified time after the Exit 2 Motor has started
rotating in the Duplex intake direction.
NOTE: When turning the power OFF, turn OFF the power switch first and then the main power
switch.
Initial Actions
Check the following:
•
A paper transportation failure due to a foreign substance/burr on the paper path
•
Each Duplex Roll and Pinch Roll for contamination, wear, and revolution failure
•
Each Exit Roll and Pinch Roll for contamination, wear, and revolution failure
•
Each Duplex Roll Drive Gear for wear and damage
•
Each Exit Roll Drive Gear for wear and damage
•
Use of paper out of spec
•
The Duplex Sensor for contamination, improper installation, and Actuator operation failure
(PL
Procedure
Check the following:
•
The Duplex Sensor for failure:
•
The connection between the Duplex Sensor
circuit, short circuit, and poor contact
•
The Duplex Motor for failure:
•
The Exit 2 Motor for revolution failure:
•
The Exit Gate Solenoid for failure:
Reload the machine software
18.2).
07/2011
2-806
BUS Updated 12/2011
Component Control
[077-105]
(PL
14.4)
P/J109
and the MCU PWB
Component Control
[077-070]
(PL
14.4)
Component Control
[077-015]
Component Control
[077-004]
(PL
(GP
16). If no problems are found, replace the MCU PWB
WorkCentre 5335 Family Service Documentation
P/J409
for open
(PL
17.5)
17.4)
(PL
Initial Issue
Advertisement
Table of Contents
