024-953 Tray 4 No Paper RAP
BSD-ON:
BSD 7.8 - Tray 4 Paper Stacking (TTM)
There is no paper in Tray 4.
Initial Actions
•
Check the tray for paper.
•
Switch the power OFF then ON.
•
Check the operation of the actuator.
Procedure
Execute
Component Control
[074-101 Tray 4 No Paper Sensor]. Activate the actuator of the
Tray 4 No Paper Sensor
(PL
10.4). The display changes.
Y
N
Go to
BSD 7.8 - Tray 4 Paper Stacking (TTM)
Sensor circuit.
Go to the
074-210
RAP to check the Tray 4 Feed LIft Motor.
•
Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
•
Check the sw version of the controller sw - update if required
Status Indicator RAPs
024-953, 024-954
and troubleshoot the Tray 4 No Paper
(GP
16)
07/2011
2-418
BUS Updated 12/2011
024-954 Tray 5 No Paper RAP
BSD-ON:
BSD 7.9 - Tray 5 (MSI) Paper Stacking
Tray 5 is out of paper.
Initial Actions
•
Power Off/On
Procedure
Execute
Component Control
[075-100 Tray 5 No Paper Sensor]. Activate the actuator of the
Tray 5 No Paper Sensor
(PL
13.2). The display changes.
Y
N
Go to
BSD 7.9 - Tray 5 (MSI) Paper Stacking
Sensor circuit.
Replace the MCU PWB
(PL
18.2).
•
Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
•
Check the sw version of the controller sw - update if required
and troubleshoot the Tray 5 No Paper
Initial Issue
WorkCentre 5335 Family Service Documentation