Table of Contents
Advertisement
073-212 Tray 3 Paper Size Sensor Broken RAP
BSD-ON:
BSD 7.3 - Tray 3 Paper Size Sensing (TTM)
Abnormal output AD value from Tray 3 Size Sensor was detected.
NOTE: When turning the power OFF, turn OFF the power switch first and then the main power
switch.
Procedure
Check the following:
•
Broken link and breakage at the bottom of the tray
•
The Actuator at the rear of the Tray for operation failure
•
The Tray 3 Paper Size Switch for failure:
[073-104]
(PL
11.12)
•
The connection between the Tray 3 Paper Size Sensor
PWB
P/J548
for open circuit, short circuit, and poor contact
Reload the machine software
(GP
16). If no problems are found, replace the Tray Module PWB
(PL
11.13).
Initial Issue
WorkCentre 5335 Family Service Documentation
Analog Monitor [073-200];Component Control
P/J102
and the Tray Module
BUS Updated 12/2011
073-900 Tray 3 Feed Out Sensor Static Jam RAP
BSD-ON:
BSD 8.3 - Paper Transportation (Tandem Tray Module)
When the power was turned ON, the M/C was stopped (Cycle Down/ Shut Down), or when the
interlocks were closed (all interlocks including options), the Tray 3 Feed Out Sensor detected
paper.
NOTE: When turning the power OFF, turn OFF the power switch first and then the main power
switch.
Procedure
Check the following:
•
The Feed Out Sensor
(PL
11.7) for remaining paper, contamination, Actuator return fail-
ure, or improper installation
•
The Feed Out Sensor for failure:
•
The connection between the Feed Out Sensor P/J108-2 and the Tray Module PWB P/J
548-B3 for short circuit
Reload the machine software
(GP
18.2).
07/2011
2-795
Component Control
[073-100]
(PL
11.7)
16). If no problems are found, replace the MCU PWB
Status Indicator RAPs
073-212, 073-900
(PL
Advertisement
Table of Contents
