Table of Contents
Advertisement
Figure 2 DADF Feeder Assembly Removal
Replacement
1.
To install, carry out the removal steps in reverse order.
2.
Align the positioning pin of the Base Frame and the hole of the DADF Feeder Assembly.
(Figure
3)
Figure 3 Align the Positioning Pin
3.
When installing the Feeder Assembly to the Base Frame, check the following
(A) At the front: The Frame of the DADF Feeder Assembly is attached to the positioning
pin of the Base Frame as shown in the figure.
(B) The Bracket of the DADF Feeder Assembly is attached to the support of the Base
Frame as shown in the figure.
Initial Issue
WorkCentre 5335 Family Service Documentation
4.
Go to
HFSI Counter
(Figure
4)
07/2011
4-17
BUS Updated 12/2011
Figure 4 Installing the Feeder Assembly to the Base Frame
and reset Counter 955-806.
Repairs & Adjustments
REP 5.5
Advertisement
Table of Contents
