Xerox workcentre 5335 series Service Manual page 1157

9. Remove the Bearing (Figure 6):
(1)Remove E-Clip.
(2)Remove Bearing.
Figure 6 Removing Bearing
10. Remove the Shaft Assembly (Figure
(1)Remove Paddle Belt from Pulley.
(2)Remove Shaft Assembly in the direction of the arrow.
Figure 7 Removing Shaft Assembly
Repairs & Adjustments
REP 12.2
7):
BUS Updated 12/2011
11. Remove the Paddle Belt (Figure
(1)Remove E-Clips (2).
(2)Move Bearings (2) in the direction of the arrow.
(3)Remove Sub Paddle Shaft Assembly.
(4)Remove Paddle Belt.
Figure 8 Removing the Paddle Belt
Replacement
1. Reverse the removal procedure for replacement.
2. Install the Paddle Link Assembly as shown in
Figure 9 Installing the Paddle Link Assembly
07/2011
4-98
8):
Figure 9.
WorkCentre 5335 Family Service Documentation
Initial Issue